Mouse Pointers; Configure - Lindy Switch User Manual

Mouse pointers

Both viewers provide a double mouse cursor to help overcome any delays
caused by slow connections. When you move your mouse you will see two
mouse cursors, a local one that responds immediately to your movements and a
second, slower moving, cursor that represents the current mouse position at the
host.
For the browser viewer, the local
cursor is a typical arrow:
Local cursor
Remote host cursor
For the VNC viewer, the local
cursor is a dot:
Local dot cursor
Remote host cursor
Additionally, for fast network
connections, the VNC viewer also
provides a single mouse mode.
See Controls - Single Mouse for
details.
Single local cursor
Host selection
The Hosts button on the menu bar provides the quickest and most efficient way
to switch between host computers. This is because the button is close at hand,
but also because the screen calibration details for each host are reused when
this method of switching is used. The alternative is to use KVM switch hotkey
combinations or the KVM switch on screen display.
Note: The Hosts button is displayed only when the
switching details for two or more computers have
been declared within the configuration section by the
admin user.
To select a host
1 Click the Hosts button to display a list of computers.
2 Click the required computer name to view and control it.
Appendix 5 - Host configuration
See
hosts into the LINDY KVM IP ('admin' user status required).

Configure

This option is displayed only when you are logged on as the 'admin' user. When
selected it provides access to a wide range of LINDY KVM IP settings.
See Appendix 5 - Remote configuration menus
for details about programming new
for more details.