HP C2858A Service Manual page 43

Message Action
Special Media Press Up Arrow for Color plotting on Special (CX) paper.
Mono Media Press Down Arrow for Monochrome plotting.
Calibrate done Accuracy calibration is complete. Press Down Arrow to continue.
!
Continue
Can't replot Replot buffer doesn't have enough memory to hold the entire plot. Re-
Resend plot send the plot.
Close roll cover Rewind the media to take up any slack in the roll, close the roll cover,
!
Continue then press Down Arrow to continue.
!
Create plot Press Up Arrow to create a calibration plot.
!
Measure plot
Press Down Arrow to measure a calibration plot.
Lift lever Lift the media lever at the right of the plotter.
Load arrow edge Remove accuracy calibration plot, turn it so that the edge with arrows
print side down printed on it is print side down, then load that edge into the plotter.
Load cancelled You pressed the Cancel button while media loading was in progress.
Remove media Remove media.
Load media Load media to proceed with pen alignment.
to align pens
Lower lever When you've finished aligning the roll media as instructed, lower the
after aligning media lever at the right of the plotter.
Lower window You have lifted the window while the processor is busy. Close the win-
to continue dow to continue.
Open window to Lift the window to access the pens.
access pens
Pen alignment Close the window to proceed with pen alignment.
Close window
Power OFF Y-Axis servo shutdown. Troubleshoot and repair.
Check Pen Path
Power OFF X-Axis servo shutdown. Troubleshoot and repair.
Check Paper Path
Installation and Configuration
3-24
Table 3 3. Action Messages