HP C2858A Service Manual page 42

Message State
Pen palette The pen source, pen number widths, and pen number shades you just en-
saved tered have been saved as either Palette A or Palette B (whichever you
specified).
Returning pens The pen carriage is returning to its station at the left of the plotter.
Roll feed Machine is trimming the edge of roll media.
Edge trim
RS-232 config The RS-232-C configuration you just entered (Config A, Config B, or
loaded Factory) has been loaded.
RS-232 config The baud, handshake, and parity settings you just entered for your
saved RS-232-C configuration have been saved as either Config A or Config B
(whichever you specified).
STATUS Machine is doing internal checking upon power-up.
Initializing
STATUS The plotter has detected that the roll is empty (you must be in Roll mode
Out of media for this to happen). If desired, remove the old roll and insert a new one.
STATUS Machine is plotting.
Plotting
STATUS Machine is ready for you to load media.
Ready for media
STATUS Machine is ready to plot.
Ready to plot
STATUS Machine has received plot data.
Receiving
Testing pens The machine is testing the pens for problems, i.e., clogged pen or bad
electrical connection (improper seating).
Table 3-2. State Messages (Continued)
Installation and Configuration
3-23