Paper Specifications; Table 1-8 Specifications For Cut Sheets (Single Sheet, Not Multipart); Table 1-9 Specifications For Cut Sheets (Multipart) - Epson LQ-2170 Service Manual

Product Description
4. Push-pull tractor feed
Set the release lever to the REAR PUSH/FRONT PUSH position.
Load paper from the front or rear entrance.
the paper eject assembly and attach the pull tractor unit.
any slack in the paper between the platen and pull tractor.
horizontal position of the pull tractor and push tractor.
carbonless.
greater than 1/6 inch.
after the paper end has been detected.

1.2.4 Paper Specifications

This section describes the printable area and types of paper that can be used in this printer.
Cut Sheets
Paper/ media specifications

Table 1-8 Specifications for Cut Sheets (Single Sheet, Not Multipart)

Minimum
Width 101 mm (4.0")
Length 147 mm (5.8")
Thickness 0.065 mm(0.0025")
Weight 52.3 g/m
Quality Plain paper, recycled paper.
Not curled, folded, or crumpled.

Table 1-9 Specifications for Cut Sheets (Multipart)

Minimum
Width 101 mm (4.0")
Length 147 mm (5.8")
Copies
Total 0.12 mm (0.0047")
thickness
Weight 40 g/m
Quality Plain paper, recycled paper.
Not curled, folded, or crumpled.
Binding A line of glue at the top or one side of the
form.
This weight is for one sheet of the multipart form.
1-8
The following table shows specifications for cut sheets.
Front Entry
Maximum
420 mm (16.5")
420 mm (16.5")
0.14 mm (0.0055")
2 2
(14 lb) 90 g/m
Front Entry
Maximum
420 mm (16.5")
420 mm (16.5")
1 original + 4 copies
0.39 mm (0.015")
2 2
(12 lb) 58 g/m
Minimum
101 mm (4.0")
101 mm (4.0")
0.065 mm(0.0025")
2
(24 lb) 52.3 g/m (14 lb)
Plain paper, recycled paper.
Not curled, folded, or crumpled.
Minimum
101 mm (4.0")
101 mm(4.0")
1 original + 4 copies
0.12 mm (0.0047")
2
(15 lb) 40 g/m (12 lb)
Plain paper, recycled paper.
Not curled, folded, or crumpled.
A line of glue at the top of the form.
LQ-2170 Service Manual
Precisely adjust the
Multipart paper must be
Do not perform reverse feeds
Do not perform reverse feeds
Rear Entry
Maximum
420 mm (16.5")
420 mm (16.5")
0.14 mm (0.0055")
2
90 g/m (24 lb)
Rear Entry
Maximum
420 mm (16.5")
420 mm (16.5")
0.39 mm (0.015")
2
58 g/m (15 lb)
Rev.A
Remove
Remove