Winding On The Hook Thread; Changing The Hook Thread Bobbin - DURKOPP ADLER 838 Instruction Manual

6.2

Winding on the hook thread

6.3

Changing the hook thread bobbin

10
2
–
Insert the thread as shown in the illustration.
–
Stick the thread behind the knife blade (1). Then cut by pulling in
the direction of arrow (2).
–
Put the bobbin on the bobbin shaft and move the bobbin lever (3) in
direction (4).
–
Start up the machine.
–
After the thread is wound around the bobbin, stick the thread once
again behind the knife blade (1) and cut off.
–
Put an empty bobbin on the bobbin shaft for the next winding
process and move the bobbin lever.
2
3
6
1
4
5
Caution: danger of injury!
Be sure to turn off the main switch and wait until the motor has
completely stopped.
–
Raise up the flap cover (1).
–
Insert the bobbin (2) with the thread end (3) positioned as shown in
the illustration.
–
Pull the thread through slit (4) and slit (5). Then close the flap and
secure the thread under the spring (6).
–
Trim off the thread end as show in the illustration.
–
The threading and bobbin insertion for the hook to the left of the
needle should be carried out similarly.
1 3 4