Winding The Bobbin Thread - Duerkopp Adler 669 Instruction Manual

6.6

Winding the bobbin thread

5 4
14
3 2
–
Put the reel on the reel stand. Guide the bobbin thread through the
unwind holder.
–
Pull the thread through guide 5, the tensioner 4, and the guide 3.
–
Clamp the thread behind the blade 6 and tear off.
–
Put the bobbin 1 on the bobbin winder.
The thread does not need to be hand wound around the bobbin.
–
Press the bobbin-winder lever 2 in the bobbin.
–
Sewing
The bobbin-winder lever ends the operation as soon as the bobbin
is full.
The bobbin winder remains in position so that the blade 6 is
properly positioned (refer to the illustration on the right).
–
Take off the full bobbin 1. Clamp the thread behind the blade 6 and
tear off.
–
Put an empty bobbin on the bobbin winder for the next winding
process and press the bobbin lever 2 into the bobbin.
Caution: danger of breakage!
If the thread is not being wound during the sewing operation, the
sewing foot must be set to the raised position and the sewing-foot
stroke must be set to the smallest value.
1 2 6