Advertisement
Step 4. To hang the fan body in the canopy, hold the fan
body firmly and insert the ball into the canopy opening.
Check that no wires were pinched. Rotate the fan body
until the slot in the nylon ball fits into the pin opposite
the canopy opening.
noTE: Independent control of
the light fixture using a W-81 re-
quires an additional power wire
run from the wall switch to the
fan. See Page 10 for wiring.
Fan Weighs 27 lbs
CANOPY ELECTRICAL CONNECTIONS
Step 4a. Attach the fan wires to the ceiling fixture
outlet box wiring by twisting the bare ends of the wires
together and then securing with a wire nut. Test that the
connection is secure by pulling on the wire nut. Conect
in this order:
Step 4b. Wiring Connections
• GREEN leads from mounting plate and fan to
GROUND conductor of power source. Secure with
wire nut.
• WHITE wire from fan to white NEUTRAL wire in
ceiling fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire in
ceiling outlet box. Secure with wire nut.
CANOPY hATCh INSTALLATION
Step 5. Tuck the wires into the canopy
with the wire nuts pointed upwards,
so that the WHITE and BLACK wires
are on opposite sides of the canopy
and all wires are clear of the canopy
opening.
Step 6. Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from the
hatch opening.
Tighten the screws firmly by hand
only,
Step 7. Straighten the fan, then check
to ensure that there is no movement
between the canopy and ceiling
or Hang-Tru ball and top support
shaft.
P
anama
hANGING ThE FAN
CANOpy
HATCH
LOCK
WASHER
CANOpy
SCREW
H
®
alo
BALL
SLOT
2 BLACK WIRES
2 WHITE WIRES
3 GREEN
WIRES
TILT THE FAN TO INSTALL
LAST CANOpy SCREW
pIN
5 5
Advertisement
