Advertisement
CROSSBAR mOUNTINg BRACKET INSTALLATION
note: After removing the old fixture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2" x 4" stud must be installed.
Step 1. Remove the knockout plug in the center of the out-
" hole for the lag screw to pass through.
let box or drill a
1
/
2
" guide hole into the joist or beam to a depth
Then drill a
1
/
4
of 3".
Step 2. Route the outlet box wires through the keyhole slot of
the crossbar mounting bracket as shown. Attach the crossbar
mounting bracket to outlet box with screws provided, assuring
that the outlet box wires are not pinched by the washer.
CAUTION: To reduce the risk of personal injury,
use only the mounting hardware provided with
the approved outlet box to install the crossbar
mounting bracket.
WARNINg!
SUPPORT DIRECTLY TO
BUILDINg STRUCTURE ONLY.
Step 3. With the large washer attached, pass the lag screw
through the center hole of the crosbar mounting bracket
and screw into guide hole. Tighten until outlet box is firmly
mounted to beam. This box must be firmly secured to the
ceiling. We recommend that the ceiling fixture outlet box
be of sufficient capacity enabling it to support the weight
of fan and light fixture under any conditions.
4
LAg SCREW INSTALLATION
JOIST
CEILINg FAN
APPROVED
WIRINg BOX
CROSSBAR
mOUNTINg
BRACKET
FLAT
WASHER
APPROVED
OUTLET BOX
HARDWARE
LAg
SCREW
LARgE
WASHER
CEILINg
WIRINg
RIDgE
SIDE
DOWN
gREEN
gROUND
WIRE
Advertisement
