Advertisement
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping
cartons and check them against the parts listed in instructions.
Before discarding packaging material, be certain that all parts have been removed.
Carton Contents
The fan carton contains the fan body, warranty card, owner's
manual, and all the parts necessary to assemble and install
your Casablanca ceiling fan. These parts are shown at the
start of each installation section. Before you start, go through
this Owner's Manual and confirm that you have all the parts
shown in each section.
CROSSBAR mOUNT-
INg BRACKET
CANOPY
HATCH
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked acceptable
for ceiling fan support.
INSTALLATION INSTRUCTIONS
gETTINg STARTED
Be sure to use only genuine Casablanca blades. The blade
shrink wrap holds 3 blades of matched weight. If more than
one fan is being installed, be sure not to mix blade sets.
CAUTION: When removing the shrink wrap, be careful not
to scratch the blades.
CEILINg HARDWARE
WIRE NUT (4)
SUPPORT INSTALLATION PARTS
lag screw
/
" #7 X 5" (1)
3
8
CANOPY HARDWARE
CANOPY
gETTINg STARTED - CONTINUED
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is a UL
listed ceiling box for ceiling fan applications. If it is not, a
new box must be installed.
M
arrakesh
addiTional hardware
2
" x 8-32 ROUNDED
1
/
4
HEAD SCREW (2)
1" x 8-32 ROUNDED
HEAD SCREW (2)
large
flaT washer
/
" (1)
3
8
CANOPY SCREW
8-32 X 4
(4)
1
/
"
8
CANOPY LOCK WASHER
#8 (4)
™
FLAT WASHER (2)
3
Advertisement
