Advertisement
Step 17. Align the motor cover key hole slots with the three
screws in the motor adapter. Once the cover clears the screw
and washers, turn counter-clockwise to engage
Step 18. Securely tighten the screws by hand until snug.
Step 19. To hang the fan body in the canopy, hold the fan
body firmly and insert the nylon ball into the canopy opening.
Check that no wires were pinched. Rotate the fan body until
the slot in the nylon ball engages the canopy pin opposite
the canopy hatch opening.
Fan weighs 40 lbs.
Step 20. Connect the fan wires to the outlet
box wiring by placing the bare ends of the wires
together and then securing with a wire nut.
Connect in this order:
• GREEN leads from mounting plate and fan to
gROUND conductor of power source. Secure
with wire nut.
• WHITE wire from fan to white NEUTRAL wire
in ceiling fixture outlet box.
Secure with wire nut.
• BLACK wire from fan to black POWER wire
in ceiling fixture outlet box.
Secure with wire nut.
Inspect each wire nut and ensure that no bare
wire is visible; pull on each wire to test the
connection is mechanically sound.
FAN PREPARATION
HANgINg THE FAN
mOTOR WIRES
DOWNROD
gROUND
CANOPY ELECTRICAL CONNECTIONS
M
arrakesh
KEY HOLE SLOT
HOUSE WIRINg
&
CROSSBAR
gROUND
&
BALL
SLOT
2 WHITE
WIRES
3 gREEN
WIRES
2 BLACK
WIRES
™
CANOPY
CANOPY
PIN
9
Advertisement
