Setting The Working Height; Sewing Drives; Types And Uses; Fitting The Sewing Drive - DURKOPP ADLER 367 Installation Instructions Manual

3.3

Setting the working height

4.

Sewing drives

4.1 Drive category, type and use
Drive type
Type
Use
4.2

Fitting the sewing drive

–
The working height is adjustable between 750 and 900 mm
(measured to the upper edge of the table plate).
–
Undo screws 4 on the stand braces.
–
Adjust the table plate horizontally to the required working height.
To prevent tilting, pull the table plate out or push it in by the same
distance on both sides.
–
Tighten both screws 4.
The following sewing drives are available:
Clutch motor
1147-F.752.3 *
1148.552.3
367-170010
367-180010
* This clutch motor incorporates an electromagnetic brake that rapidly
stops the rotor when it runs on after the motor has been switched off.
This prevents the sewing machine from starting up unintentionally if
the pedal is operated shortly after switching off.
–
Attach the sewing drive 5 with its base 6 on the underside of the
table plate.
By screwing the three hexagonal screws 3 (M8x35) with washers 2
into the table-plate nuts 1.
Clutch
positioning drive
VD552KV/6F82FA
367-170010
367-180010
DC
positioning drive
DC1600/DA82GA
367-170010; -180010
367-170115; -180115
367-170315; -180315
9