Attaching Drive Cables - TYAN S7020 User Manual

2.9 Attaching Drive Cables

Attaching Serial ATA Cables
The S7020 is equipped with 6 Serial ATA (SATA) channels. Connections for
these drives are very simple.
There is no need to set Master/Slave jumpers on SATA drives.
TYAN has supplied two SATA cables and one SATA power adapter. If you are
in need of other cables or power adapters please contact your place of purchase.
The following pictures illustrate how to connect an SATA drive
Attaching Floppy Drive Cables
Attaching floppy diskette drives are done in a similar manner to hard drives. See
the picture below for an example of a floppy cable. Most of the current floppy
drives on the market require that the cable be installed with the colored stripe
positioned next to the power connector. In most cases, there will be a key pin on
the cable which will force a proper connection of the cable.
SATA drive cable connection
2. SATA drive power
connection
3. SATA cable motherboard
4. SATA drive power adapter
33
http://www.tyan.com
connector
Attach first floppy drive
(drive A:) to the end of
the cable with the twist
in it. Drive B: is usually
connected to the next
possible connector on
the cable (the second or
third connector after you
install Drive A:).