Finishing Up - TYAN S5512 User Manual

PWR 2: 8-Pin PWR Connector
Apply power to the motherboard:
1.Connect to the EPS12V 8 pin Power Connector
2.Connect to the EPS12V 24 pin Power Connector
3.Connect power cable to Power Supply and power outlet.
Look to the www.TYAN.com website for further information.
YOU MUST unplug the power supply before plugging the power cables
to motherboard connectors.

2.13 - Finishing Up

Congratulations on making it this far! You're finished setting up the hardware
aspects of your computer. Before closing up your chassis, make sure that all
cables and wires are connected properly, especially power cables and most
importantly, jumpers. You may have difficulty powering on your system if the
motherboard jumpers are not set correctly. In the rare circumstance that you
have experienced difficulty, you can find help by asking your vendor for
assistance. If they are not available for assistance, please find setup
information and documentation online at our website or by calling your
vendor's support line.
Pin
1
3
5
7
PIN1
http://www.TYAN.com
Signal Pin
2
GND
GND 4
+12V 6
+12V 8
46
Signal
GND
GND
+12V
+12V