TYAN S5512 User Manual page 30

JP6：RTC Clear CMOS set
Normal
(Default)
Clear CMOS
JP7：ME update function set
Onboard ID LED
+
Note:
You can identify the specific system using this LED.
Users from remote site could also activate ID LED by
input a few commands in IPMI, detailed software
support please visit
AST2150 user guide.
You can reset the CMOS settings by using this
jumper if you have forgotten your
system/setup password or need to clear
system BIOS setting.
-
-
-
-
-
-
Pin
+
-
-
State
On
Off
http://www.tyan.com
http://www.TYAN.com
1.Power off system and disconnect both
power connectors from the motherboard
2.Put jumper cap back to Pin_1 and Pin_2
(default setting)
3.Use jumper cap to close Pin_2 and Pin_3
for several seconds to Clear CMOS
4.Reconnect power & power on system
：
Pin1-Pin2 NORMAL (Default)
Pin2-Pin3: CLOSE (ME update function)
Signal
V3AUX
GND
Color
Blue System identified
Off System not identified
30
Description
for lastest