Advertisement
Contents
1
2
3
4
Safety Information
5
6
7
8
Spare Parts List
1
Scope of Application
This Sliding Carriage is intented for use with the Elekta Beckum Spindle Moulder models TF900/TF904. It is used
for working across the endgrain of timber having a square or rectangular crossection.
- Please observe all relevant safety regulations for the use of spindle moulders applicable in your area.
When in industrial use in the U.K. use of this accessory falls under the 1974 Woodworking Regulations. In the
interest of health & safety of the machine user we recommend you study and follow these regulations.
We would also draw your attention to the booklet "Woodworking Machines Regulations 1974-Guidance on
Regulations" ref. L4 /ISBN 0118855921) published by HSMO.
2
Specifications
Table size:
Carriage travel:
Fence:
Graduation:
Carriage guides:
Max. allowable workpiece weight:
Mounting:
Workpiece clamping:
3
Product Liability/Warranty
This product carries a 12 month manufacturer warranty under the prevailing legal provisions, which may vary from
country to country. The warranty period begins with the date of the original purchase by the end user. Proof of
purchase should be retained and must be presented in the event of a warranty claim. This warranty excludes and
does not cover defects, malfunctions and failures caused by natural wear, overload, unreasonable use or failure
to provide reasonable and necessary maintenance.
In case of a defect notify your dealer or Elektra Beckum distributor, who will decide how to handle your claim.
Warranty claims can only be taken care of by your Elektra Beckum dealer or authorized service centre.
This product or any of its parts should not be altered or changed from standard specifications. The user of this
product shall have the sole responsibility for any malfunction which results from improper use or unauthorized
modification from standard specifications, faulty maintenance, damage or improper repair by anyone other than
qualified person approved by Eleketra Beckum or its representatives.
4
Safety Instructions
Feeding the workpiece with a sliding carriage is considered semi-mechanical feed. The cutterheads and moulding
tools used must be approved for mechanical feed. Always perform such moulding operation with the cutterhead
running at counterrotation, i.e. the cutterhead is turning against the direction of feed of the workpiece. Always have
the workpiece firmly secured to the sliding carriage's table with the clamps provided.
280 x 525 mm
700 mm
adjustable 45 through 90
1
4 rollers, on ball bearings
20 kg
quick-action locks
quick-action clamp
ENG
Advertisement
