Mounting The Sewing Drive; Mounting The Pedal - Duerkopp Adler 171 Instruction Manual

4.3 Mounting the sewing drive

6

4.4 Mounting the pedal

8
8
7
5
–
Fasten the sewing drive 2 with its base 1 to the underside of the
table top.
For this purpose screw the 3 hexagonal bolts (M8 x 15) with
washers in the screwed inserts 8 of the table top.
–
Fasten pedal 4 on the stand strut 3.
–
Align pedal 4 as follows for ergonomical reasons:
The center of the pedal has to be approximately under the needle.
The stand strut 3 is equipped with slotted holes for aligning the
pedal.
–
Screw the ball pin from the central bore into the front bore of
lever 7.
–
Hang in the pedal rods 5.
–
Loosen screw 6 slightly.
–
Adjust the height of the pedal rods 5 as follows:
The discharged pedal 4 should have an inclination of approx. 10°.
–
Tighten screw 6.
1
2
3
4