Setting The Machine-Specific Parameters - Duerkopp Adler 171 Instruction Manual

6.4 Setting the machine-specific parameters

6.4.1 General notes
6.4.2 Autoselect
–
Plug the cable of the reference value transmitter (pedal) into
bushing B80 of the control.
–
Plug the cable of the motor sensor 1 into bushing B2 of the control.
–
Plug the cable 2 of the motor into bushing B41 of the control.
–
Plug the cable to the sewing machine into bushing A of the control.
–
Run all cables through the cable duct.
–
Cable of the control panel (optional equipment) into bushing B776.
The functions of the sewing drive control are determined by the
program and the setting of parameters.
Upon delivery of the sewing drives the parameter values are preset by
Efka (preset values). For every class and subclass some parameters
have to be changed in the „technician level" and some in the „supplier
level" in order to optimally adapt the control to the machine. The
parameters concerned are listed on the parameter sheet (in the
accessories) .
The parameter 290 (selection of the machine class) has to be set to
the value 1 (for cl. 171) / value 2 (for cl. 173) in the "supplier level".
Furthermore, the parameter 170 (setting of the reference position) has
to be set in the "technician level". The setting "position (EP)" is the
penetration point of the needle into the throat plate.
Please take the detailed description of the control from the attached
current operating instructions of the motor manufacturer (see also
www.efka.net).
By measuring the Autoselect resistance in the machine the control
"recognizes" which machine series is connected. By means of
Autoselect control functions and the preset values of the parameters
are selected. If no Autoselect resistance or an invalid one is
recognized by the control, the drive will run with the so-called
emergency operation functions only in order to protect the machine
from being damaged.
GB
15