Assembling And Connecting The Sewing Drive; General; Mounting The Sewing Drive Beneath The Table Plate - Duerkopp Adler 69 Installation Instructions Manual

4.

Assembling and connecting the sewing drive

4.1

General

Drive units
Complete drive units are available for the 69.
The drive unit depends on what attachments are fitted to the special sewing machine.
The following table shows which drive unit is required depending on the subclass and
optional extras.
subclass sewing drive
69-373 FIR1147-F-554.3
Efka VD554KV/6F62AV
Quick QD554/A51K01
69-FA-373 Quick QD554/A51K01
Components of all drive units:
– sewing drive
– pedal linkage
– V-belt pulley (Ø = 112 mm)
– V-belt
– installation plan
– attachment and connection material
Extra components for FIR 1147-F-554.3 drive unit:
– mains switch with attachment material and connection leads
Extra components for Efka VD554KV/6F62AV and Quick QD554/A51K01 drive units:
– holder for proximity switch
– earth lead
– motor-protection switch (2,5 - 4,0 A) with attachment material and connection leads
– AB4 operating panel (only for Quick QD554/A51K01)
4.2

Mounting the sewing drive beneath the table plate

– Attach sewing drive 6 (Quick in the illustration) with its base 2 to the underside of
the table plate 7 or right-hand half of the table plate 5 (MG 56-2 frame).
Screw in the three hexagonal screws 4 (M8 x 35) with washers 3 into the nuts 1 of
the table plate.
operating panel optional extra
FLP 14-2 RAP 14-1 HP 11-1
-
- X
AB4
AB4 X
X X
X X
9