TYAN Tomcat i945GM S3095 User Manual page 73

67H TP_MP_INIT_MIN
68H TP_CACHE_CONFIG
69H TP_PM_SETUP_SMM
6AH TP_DISP_CACHE
6BH TP_CUST_DFLT
6CH TP_DISP_SHADOWS
70H TP_ERROR_MSGS
72H TP_TEST_CONFIG
74H TP_RTC_TEST
76H TP_KEYBOARD
7AH TP_KEYLOCK
7CH TP_HW_INTS
7DH TP_ISM_INIT
7EH TP_COPROC
80H TP_IO_BEFORE
81H TP_LATE_DEVICE_INIT
82H TP_RS232
83H TP_FDISK_CFG_IDE
84H TP_LPT
85H TP_PCI_PCC
86H TP_IO_AFTER
87H TP_MCD_INIT
88H TP_BIOS_INIT
89H TP_ENABLE_NMI
8AH TP_INIT_EXT_BDA
8BH TP_MOUSE
8CH TP_FLOPPY
8EH TP_AUTOTYPE
8FH TP_FDISK_FAST_PREINIT
90H TP_FDISK
91H TP_FDISK_FAST_INIT
92H TP_USERPATCH2
93H TP_MP_INIT
95H TP_CD
96H TP_CLEAR_HUGE_ES
97H TP_MP_FIXUP
98H TP_ROM_SCAN
99H TP_FDISK_CHECK_SMART
9AH TP_MISC_SHADOW
Quick initializes of all AP's in early post.
(Optional)
Enables cache(s).
Performs SMM initializations. (Optional)
Displays cache RAM size if desired.
(Optional)
Displays BIOS shadow status.
Displays any errors found.
Checks for bad configurations.
(Optional)
Reports if there was a keyboard or
controller failure.
(Optional)
Initializes hardware interrupt vectors.
(Optional)
Tests for coprocessor.
(Optional)
POST device initialization routine.
(Optional)
(Optional)
Configures Non-MCD IDE controllers.
(Optional)
Configures PnP PCC devices. (Optional)
(Optional)
Configures MCD devices.
Initializes timeouts, key buffer, soft reset
flag.
Enable NMIs.
Initializes extended BIOS data area.
Checks if mouse is installed, displays
"Installed" message. (Optional)
POST task for installing and initializing
legacy floppy disk drives.
(Optional)
(Optional)
Tests hard disks.
Programs timing registers according to PIO
modes. (Optional)
Jump to UserPatch2.
Creates the MP table. (Optional)
Installs CD-ROM for boot. (Optional)
Performs a shutdown eight to transition
from the warm start table to the cold start
table. (Optional)
Fix-up MP table physical pointer and
checksum. (Optional)
Configures Non-PCC PnP ISA devices, PCI
IRQs, enables PCI devices and rom scan.
POST task to check SMART status.
(Optional)
(Optional)
73