Table of Contents
Advertisement
PATA IDE Mode
This selects the mode for the PATA controller.
[Primary] IDE is Primary Channel (IDE channel1). Secondary Channel (IDE
channel2) master is SATA2 and Slave is SATA4.
[Secondary] IDE is Secondary Channel (IDE channel2). Primary Channel (IDE
channel1) master is SATA1 and slave is SATA3.
SATA Port
This item is read only.
3.6.2 Super IO Device
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install an add-in FDC or the system
has no floppy drive, select "Disabled" in the field.
• Enabled
• Disabled
Onboard Serial Port 1/2
Select an address and corresponding interrupt for the first or second serial port.
• 3F8/IRQ4
• 2F8/IRQ3
• 3E8/IRQ4
• 2E8/IRQ3
• Auto
54
Advertisement
Table of Contents
