TYAN Tomcat i945GM S3095 User Manual page 43

Intel 945gm and ich7m-dh chipsets
Table of Contents

Advertisement

Boot Other Device
This option allows the system to boot from any other bootable device.
• Enabled
• Disabled
Boot Up Floppy Seek
During Power-On Self-Test (POST), BIOS will determine if the floppy disk drive
installed is 40 or 80 tracks.
• Enabled
• Disabled
Boot Up NumLock Status
This option, when enabled, automatically turns on your NumLock key when the
system is booted. This is a matter of personal taste.
• On
• Off
Security Option
Setting this option to System will set the BIOS to ask for the password each
time the system boots up. If you choose Setup, then the password is only
required for access into the BIOS setup menus.
• Setup
• System
MPS Version Control For OS
This feature is only applicable to multiprocessor motherboards as it specifies
the version of the Multi-Processor Specification (MPS) that the motherboard will
use. The MPS is a specification by which PC manufacturers design and build
Intel architecture systems with two or more processors.
MPS 1.1 was the original specification. MPS version 1.4 adds extended
configuration tables for improved support of multiple PCI bus configurations and
greater expandability in the future.
In addition, MPS 1.4 introduces support for a secondary PCI bus without
requiring a PCI bridge. Select the MPS version depending on the operating
system installed: select 1.1 for Win NT
3.52, and 1.4 for Win NT4.0, Win2000, and WinXP.
• 1.1
• 1.4
Report No FDD For OS
Set this option to Yes if you are using Windows 95/98 without a floppy to
release IRQ6 (this is required to pass Windows 95/98's SCT test and get the
logo).
• No
• Yes
43

Advertisement

Table of Contents
loading

Table of Contents