Advertisement
Setting Console/Receiver(s) to Same ID
Use this procedure instead of the one found at the top of page 5 in the Installa-
tion Manual.
Identify the Firmware Date on the Vantage Pro Console
1.
Press and hold the DONE key and press the "+" (up arrow) key at the
same time.
The firmware rev and date will scroll across the bottom of the LCD screen.
2.
Write the firmware date down: ________________________________
Setting the Vantage Pro Console
1.
Put your console into Setup Mode — press and hold the DONE key and
press the "-" (down arrow) key.
The console will show you Screen 1: Transmitters. You should see the
words: "RECEIVING FROM..." and "STATION NO." followed by the trans-
mitter IDs that your console detects. One of these should be the ID number
you just set on the temperature station transmitter. If you don't see it, make
sure the console is within 10' of the transmitter, and verify that you set the
DIP switches correctly. If you still don't see it, refer to the "TEST mode" sec-
tion on page 6 of the Installation Manual.
2.
Press the DONE key to move on to Screen 2: Selecting Transmitters.
Setup Mode – Screen 2 is where you will set the console to recognize signals
on the selected ID as coming from a temperature station.
3.
Press the LEFT or RIGHT arrow key, or the STATION key, to scroll
through transmitter IDs.
When you see the ID you chose for the temperature station, use the "+" (up
arrow) or "-" (down arrow) keys to activate reception of that ID code. Make
sure the screen shows "ON".
4.
Press the GRAPH key to change the type of station assigned to that trans-
mitter ID.
Press the GRAPH key until the word "TEMP" appears.
5.
For firmware dated before January 2003: If you don't see a "4X" next to
the station type, press the HI/LOW key once.
A "4X" should appear next to the station type.
6.
For firmware dated January 2003 or later: If you don't see a "4X" next to
the station type, Press and hold the TEMP key then press the HI/LOW
key once.
A "4X" should appear next to the station type.
7.
To exit Setup Mode, press and hold the DONE key.
8.
Continue with the installation as described in the Wireless Temperature
Station Installation Manual, starting with Viewing Current Temperature
on page 5.
Setting Console/Receiver(s) to Same ID
Page 3
Advertisement
