Table of Contents
Advertisement
PJ Camera Software Modes and
Basic Operations
This section explains the five modes you can access using PJ Camera Software, and about
the operation bar that you use to perform actual PJ Camera Software operations.
Using PJ Camera Software Modes
PJ Camera Software has the following five modes.
Before recording an image or performing an operational procedure, be sure to select the
correct mode first.
If you startup PJ Camera Software in the Business Document startup mode, you will be
able to use the Document Camera Mode or Presentation Mode only. You will not be able
to perform Projection Area Capture or Board Area Capture in the Presentation Mode if
you start up in the Business Document startup mode.
When you want to do this:
Record the image of a
document or object
Record the image of a
document or object and save
it in an image file
Project images from files
stored on a computer
Project images in a specific
sequence from files stored
on a computer
Document Camera Mode
Scanner Mode
PC Image Mode
Select this mode:
Document Camera Mode
With this mode, you can use the PJ Camera to record the
image of a document or object on the PJ Camera Stand,
and then project it. An image is recorded automatically
whenever you place a document on the PJ Camera Stand,
which means that operation is similar to that of an OHP
projector.
Scanner Mode
With this mode, you can use the PJ Camera to record the
image of a document or object on the PJ Camera Stand,
and then store it as an image file. During recording, you can
view a pre-recording monitor image, release the shutter,
check the recorded image, and perform other operations from
your computer.
PC Image Mode or Scanner Mode
These modes can be used to project images that have been
recorded in the Scanner Mode or with the PJ Camera and
stored on a computer.
PC Image Mode or Scanner Mode
Create a play list to specify the projection sequence.
Camera Image Mode
Presentation Mode
16
Advertisement
Table of Contents
