More Information; Troubleshooting - Rotel RSP-1570 Owner's Manual

English English
entered password is correct, the current settings will be saved as the
new USER DEFAULT settings.
3. To return to the MAIN menu without saving changes, change all
entries on the screen to NO and press ENTER.
Note: If there is insufficient memory to store a USER DEFAULT
configuration file, the SET USER DEFAULT option will not be
available.
To activate memorized USER DEFAULT settings: After you have
stored a USER DEFAULT configuration file, you can activate those settings
at any time by placing the highlight on the USER DEFAULT line using the
UP/DOWN buttons. Use the +/– buttons to change the setting to YES.
Press the ENTER button to proceed with activating the USER DEFAULT
settings. To return to the MAIN menu without activating the USER
DEFAULT settings, change the entry to NO and press the ENTER button.
To return to the MAIN menu without activating the USER DEFAULT
settings, change the entry to NO and press the ENTER button.
To change the password: The password programmed at the factory is
0000. If you wish to change the password:
1. Place the highlight on the SET NEW PASSWORD line using the UP/
DOWN buttons. Use the +/– buttons to change the setting to YES.
Press the ENTER button to proceed to the PASSWORD screen.
2. Enter the four digits of the old password by pressing the +/– buttons
to select the first letter of the new password, then pressing ENTER
to move to the second character. Repeat until the old password is
entered. Successful entry of the old password will jump to the ENTER
NEW PASSWORD line.
3. Enter the four digits of the new password by pressing the +/– buttons
to select the first letter of the new password, then pressing ENTER
to move to the second character. Repeat until the new password is
entered.
4. You will be asked to re-enter the password again on the CONFIRM
PASSWORD line, following the same procedure. Once the password
is successfully confirmed, it will be saved and you will return to the
DEFAULT SETUP MENU automatically.
5 To exit the PASSWORD screen without changing the password,
highlight the DEFAULT SETUP MENU line and press ENTER to return
to the previous screen.
Note: The factory password is 0000. A default password that will
always be recognized is 8888.

MORE INFORMATION

Troubleshooting

The unit does not turn on.
• Make sure the power cord is plugged into the rear panel and a live
AC outlet.
• Make sure the rear panel POWER switch is in the ON position.
No sound from any input.
• Make sure that MUTING is off and VOLUME is turned up.
• Make sure that preamp outputs are connected to a power amplifier
and that the amplifier is turned on.
• Make sure source inputs are connected and configured correctly.
• Check that the setting for HDMI AUDIO in the VIDEO/HDMI on-
screen menu is AMP MODE.
No sound from digital sources.
• Make sure that digital input connector is assigned to the proper
source input and that the source input is configured to use the digital
input rather than an analog input.
• Check the configuration of the DVD player to ensure that the
bitstream and/or DTS digital output is activated.
No sound from some speakers.
• Check all power amp and speaker connections.
• Check Speaker Configuration settings in the Setup menus.
No video output on TV monitor.
• Make sure that the TV monitor is connected properly and check the
input assignments. S-Video and Composite Video TV monitors can
only be used with interlaced SD sources. HDMI and Component
TV monitors can be used with Standard Definition (SD) and High
Definition (HD) sources. An HDMI 1080p source can only be sent to
a 1080p-compliant TV monitor.
• Component Video output at 720p or 1080i may not be available if
the source signal includes HDCP copy protection.
• HDMI cables must be 5 meters or less in length.
OSD menus are not displayed on TV Monitor.
• In some PAL systems, the menus may not be displayed unless there is
an active video signal.
Video and Audio do not match.
47 47