Installation - Burley Stroller Kit Owner's And Safety Manual

Tools Required:
(2) 10mm open end wrenches
(1) 25mm (or 1") wrench
(1) 5mm hex wrench

Installation

1. Remove tow bar from trailer.
2. Remove nut and bolt from tow bar end. Discard bolt and lock
nut. Safety strap and D-ring will be re-installed. Figure 2
3. Slide stroller kit onto tow bar. Figure 3
4. Place D-ring and safety strap on supplied 6mm x 50mm bolt.
Line up holes in stroller kit, tow bar and flex connector and
install bolt. Secure with nut. Install two shorter bolts through
pivot assembly side and secure with nuts. Figure 4
B U R L E Y S T R O L L E R K I T O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
|
3