LG LDE3037SB Owner's Manual page 33

EasyClean™ INSTRUCTION GUIDE
STEP
Remove oven racks and accessories from the oven.
1
Scrape off any burnt-on debris with a plastic scraper. Suggested plastic scrapers:
2
• Hard plastic spatula
• Plastic pan scraper
• Plastic paint scraper
• Old credit card
Using a spray bottle, spray 1/4 cup (2oz) of water to fully saturate the walls
3
and soils in the corners of the oven. Then spray (or pour if spraying is difficult)
another 1 cup (8oz) of warm water onto the bottom center of the oven cavity.
The indentation on the oven bottom should be fully covered to submerge all soils.
Additional water spray may be used as necessary.
NOTE : DO NOT SPRAY WATER DIRECTLY ON THE DOOR.
DOING SO WILL RESULT IN WATER DRIPPING TO THE FLOOR.
4 Close the oven door and press EasyClean™, and then press Start.
5 A tone will sound at the end of the 20-minute cycle. Press the Clear/Off button to
clear the display and tone.
6 Place a towel in front of the oven, underneath the lower oven door, to capture any
water that may spill out during cleaning.
7 Clean the oven cavity immediately after the EasyClean™ cycle by scrubbing with a
wet, non-scratch scouring sponge or pad (the scouring side will not scratch the
finish). Some water may spill into the bottom vents while cleaning, but it will be
captured in a pan under the oven cavity and will not hurt the burner.
NOTE: DO NOT USE ANY STEEL SCOURING PADS, ABRASIVE PADS OR CLEANERS
as these materials can permanently damage the oven surface.
8 Once the oven cavity is cleaned, wipe any excess water with a clean dry towel.
Replace racks and any other accessories.
9 If some light soils remain, repeat the above steps, making sure to thoroughly soak
the soiled areas. If stubborn soils remain after multiple EasyClean™ cycles, run
the Self Clean cycle. Be sure that the oven cavity is empty of oven racks and other
accessories, and that the oven cavity surface is dry before running the Self Clean
cycle. Consult the Self Clean section of your owner's manual for further details.
CAUTION
• Some surfaces may be hot after the EasyClean™
cycle. Wear rubber gloves while cleaning to prevent
burns.
• During the EasyClean™ cycle, the oven bottom
becomes hot enough to cause burns. Wait until the
cycle is over before wiping the inside surface of the
oven. Failure to do so may result in burns.
• Avoid leaning or resting on the oven door glass
while cleaning the oven cavity.
EasyClean™ INSTRUCTION GUIDE
CARE AND CLEANING
Use the "mist" setting on
the spray bottle for better
coverage. The entire 1 1/4
cup (10oz) of water should
be used for each oven
cavity.
NOTE
• If you forget to saturate the inside of the oven with
water before starting EasyClean™, press the CLEAR/
OFF button to end the cycle. Wait for the range to
cool to room temperature and then spray or pour
water into the oven and start another EasyClean™
cycle.
• The cavity gasket may be wet when the EasyClean™
cycle finishes. This is normal. Do not clean the
gasket.
• If mineral deposits remain on the oven bottom after
cleaning, use a cloth or sponge soaked in vinegar to
remove them.
33
NOTES