Using The Cooktop; Cooking Areas; Using The Cooktop Elements - LG LDE3037SB Owner's Manual

USING THE COOKTOP

COOKING AREAS

The cooking areas on your range are identified by
permanent circles on the glass cooktop surface. For the
most efficient cooking, fit the pan size to the element size.
Pans should not extend more than 1/2 to 1-inch
beyond the cooking area.
When a control is turned on, a glow can be seen through
the glass cooktop surface. The element will cycle on and
off to maintain the preset heat setting, even on Hi.
Warming zone
Double element
Hot surface indicator
HS (Hot Surface) will appear in the display once the
element is turned off or during the self clean cycle. The
HS indicator will stay on until the surface has cooled to
approximately 150°F (66°C) or when the self clean cycle
ends.
CAUTION
It is normal for the surface elements to cycle on and
off during cooking, even on higher settings. This
will happen more frequently if cooking on a lower
temperature setting.

USING THE COOKTOP ELEMENTS

To turn on a SINGLE element (left and right rear
elements):
1. Press the ON/OFF button that controls the element
2. Press the + button once to adjust the element
3. Use the – / + buttons to adjust the element
Single element
4. To turn off the element after cooking, press the ON/
• Hi is the highest temperature available.
• Lo is the lowest temperature available.
• Press and hold the + or – buttons to quickly scroll
through the temperature settings.
• NEVER leave food on the cooktop unattended.
Spillovers can cause smoke. Greasy spillovers may
catch on fire.
• The oven surface element may appear to have
cooled after it has been turned OFF. The element
may still be hot and burn may occur if this element
is touched before it has cooled sufficiently.
USING THE COOKTOP
that you would like to use (refer to the below cooktop
element control image).
temperature to Hi, or the – button once to adjust the
element temperature to Lo.
temperature settings. The element temperature
settings are adjustable at all times.
OFF button once.
Warming zone control
Dual element controls
NOTE
CAUTION
17
Single element
controls