HP Kayak XW U3-W3 Handbook page 13

HP Kayak XU Series 03xx and HP Kayak XW Series U3, W3
The Matrox Millennium G200 has a 8 MB of SGRAM memory already supplied
on the graphics controller board. Memory may be upgraded to a maximum of
16 MB by installing a 8 MB SGRAM memory module onto the board.
The Matrox Millennium G400 has 16 MB of SGRAM installed and cannot be
upgraded.
The ELSA GLoria Synergy+ includes 8 MB of video SGRAM memory installed
on the graphics board and cannot be upgraded.
3
For the above mentioned graphics controllers, no switch or jumper settings
need to be changed (all jumpers should be left in the positions in which they
were set by the manufacturer).
WARNING:
AccelEclipse II AGP Graphics Hardware Accelerator
Display connector
The HP Kayak XW Series U3 (models D6480N, D6481N, D6481T and D6482N)
contain an AccelEclipse II AGP OpenGL 3D graphics hardware accelerator.
There is a total of 32 MB of memory, already supplied on the graphics controller
board. There are no upgrades possible, and no switch or jumper settings to be
changed (all jumpers should be left in the positions in which they were set by
the manufacturer).
In case of failure, the whole video board has to be replaced.
3-12 HP Kayak XU Series 03xx and HP Kayak
XW Series U3, W3
Video memory upgrade modules for the Matrox
Millennium II and the Matrox Millennium G200 video
controller are not compatible.
Cooling fan
AGP bus connector
Mini-Tower
PC Workstations