Alpine MULTIMEDIA MANAGER PXA-H701 Owner's Manual page 35

Installation and Connections
3
Mount the spacer and bracket to the control unit.
Next, securely mount the factory brackets
removed from the factory radio, to the control
unit assembly.
Flat head screws (M5 x 8)
Bracket
Flush Mounting the control unit
1
Make a cut-out approximately 178 (width) by 50
(height) mm (7 inches by 2 inches) in size at your
desired mounting location.
WARNING
When making cut-outs, be careful not to
damage pipes, tanks, electric wires, etc. Doing
so could lead to accidents or fire.
2
After step 2 on "Mounting other units" of
"Mounting the control unit" page 33, remove the
side bracket.
Side bracket
3
Remove the spacer from the bracket.
Spacer
34
-EN
4
5
Side bracket
Bracket
Mount the spacer on the control unit using the
included screws.
Spacer
Control unit
Attach the flush mount brackets to the control
unit using the included screws. Mount this
assembly into the prepared cut-out.
Flush mount
Face plate
Pan head screw
(M3 x 5) x 2
Self-tapping screw
(M2.6 x 8) x 4