Bunn Axiom Series Programming Manual page 11

ADJUSTMENTS & OPTIONAL SETTINGS (CONT.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
ENABLE BrewLOGIC
NO DONE
Go to
SPRAY OZ/M:
PLACE BREWER IN
FINAL LOCATION
CALIBRATE NOW?
NO
ACCURACY RISK!!!
OK
Go to CAL
LP1-LP2
TOO HOT-WILL
COOL TANK NOW
PRESS BREW WHEN
CONTAINER READY
COOLING TANK
PLEASE WAIT
The BrewLogic system allows the brewer to be calibrated to
high mineral locations and compensate as deposits build up
YES
internally. Press YES, then press DONE. Follow the prompts.
Pertains only to software version 1.07 & above!
Select a sturdy, level location.
Brewer must not be bumped during calibration!
Select YES for calibration. Selecting NO warns of accuracy
risk
YES
Select CAL. to start calibration procedure. Selecting OK will
skip to level probe calibration screen.
CAL.
Automatically checks to see if tank temperature is between
130°-170°F (54°-76°C)
Verify brew funnel and decanter/airpot/thermal server (depend-
ing on which model you have) are in place. Then press the
"BREW START" button.
Message will be displayed while dispense is being performed.
Tank heaters are turned off and the unit will dispense for ~1
minute to cool tank temperature.
(CONT.)
Page 11 41154 041708