Mounting The Hood To Support Frame; Installing The Electrical - Electrolux E40PV100FS Use & Care Manual Installation Instructions

MOUNTING THE HOOD TO SUPPORT FRAME

1 Insert four (4) bolts through the top of the hood from the inside.
2 Use four (4) nuts and four (4) washers to secure hood to support frame.

INSTALLING THE ELECTRICAL

WARNING
Electrical wiring must be done by a qualified person(s) in accordance with all applicable
codes and standards. This range hood must be properly grounded. Turn off electrical power
at service entrance before wiring.
1 Remove the wiring box cover. Remove a knockout from the wiring
box.
2 Feed 6" of power cable through the knockout opening and secure
cable to the wiring box with an appropriate connector.
3 Make electrical connections. Connect white to white, black to black
and green to green.
4 Replace wiring box cover and screws. Check that wires are not
pinched between cover and box.
Installation
WIRING BOX COVER
17
WASHER
NUT
BOLT
Figure 12
Figure 13