Safety IMPORTANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Warning or Caution based on the risk type. Definitions This is the safety alert symbol.
SAFETY PRECAUTIONS WARNING WARNING WARNING WARNING WARNING • To reduce the risk of fire, electric shock, or injury to persons, observe the following: a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
Page 6
Safety UTION UTION CAUTION UTION UTION To reduce the risk of fire and electric shock, install this retractable ventilation unit only with remote blower models rated maximum 8 amp (total of all interconnected remote blowers).
Preparing for Installation VERIFY PACKAGE CONTENTS • Use & Care Guide • Anchoring Legs and Hardware INSTALLATION PLANNING A qualified technician must complete the installation of this appliance. Proper installation is your responsibility. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting.
Electrical Power Supply REQUIREMENTS WARNING WARNING WARNING WARNING WARNING Failure to disconnect power may result in electrical shock or fire hazard! If the electric service provided does not meet the product specifications, do not proceed with the installation. Call the selling dealer or a licensed electrician. It is the owner’s responsibility to ensure that the electrical connection of this appliance is performed by a qualified electrician.
Duct Preparation DUCT INSTALLATION WARNING WARNING WARNING WARNING WARNING • To reduce the risk of fire and to properly exhaust air, ducted fans must be vented to outside. Do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces or garages.
Page 11
Model Duct Maximum Equivalent Straight Lengths Size E30DD75ESS 10” E36DD75ESS 3 1/4” x 10” E46DD75ESS E48DD75ESS We recommend using a certified HVAC contractor for all installations.
Page 12
Duct Preparation 3. Add (1) and (2) to determine the total equivalent straight length of the complete duct system: 25’ + 15’ + 4’ = 44’ total equivalent straight duct length. 4. For the system with 3 ¼” x 10” duct, the maximum allowable total equivalent straight length of duct is 60 feet.
IMPOR Verify that the raised vent and blower being installed are a matched pair before beginning the installation. (Part number 5304444802 and E30DD75ESS, E36DD75ESS, E46DD75ESS, and E48DD75ESS.) For installation of the raised vent system, provide an opening in the countertop as shown in the Countertop Preparation section.
Page 15
Countertop Preparation Vertical non-combustible surface rear wall 25" (635mm) 19 7/8" 23 1/4" (505mm) (591mm) Min. Overall Cutout Dimensions (E46GC66ESS and E46GC67ESS) Figure 4 Backsplash Max.3/4" (19mm) 1/4" (6mm) Min. flat ledge Flush with backside of cabinet front 7 1/2" (191mm) Min. to combustible side walls above the range (both sides)
Installation INSTALLING THE DOWNDRAFT VENT IMPOR IMPORT T T T T ANT IMPOR IMPOR IMPOR The vent must be installed in a vertical orientation. Do not mount the vent on a slant or angle. Remove the knockout from the plenum by cutting the tape and metal cross overs to remove the insert.
MAKING THE ELECTRICAL CONNECTION WARNING WARNING WARNING WARNING WARNING • Ensure that the power supply is disconnected before proceeding. • Verify that the power supply matches the ratings found on the appliance data plate before proceeding. • The complete appliance must be properly grounded at all times when electrical power is applied.
Installation INSTALLING WITH A COOKTOP WARNING WARNING WARNING WARNING WARNING • The cooktops have very different installation requirement. Please make sure you read the Installation Instructions for the accompanying cooktop thoroughly before continuing the installation process. • After the cooktop has been installed ensure that the top cap on the vent intake does not catch on the back edge of the cooktop when the intake is lowered.
VERIFYING THE OPERATION WARNING WARNING WARNING WARNING WARNING • If the vent system is not operational after completion of the installation, do not attempt to repair it. See the Problem Solving section of the Use & Care Guide, then call a qualified service technician if the system is still not functional. •...
Page 20
E l e c t r o l u x R e t r a c t a b l e V e n t i l a t i o n S y s t e m s E30DD75ESS...
Page 21
Safety IMPORTANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Warning or Caution based on the risk type. Definitions This is the safety alert symbol.
Page 22
SAFETY PRECAUTIONS WARNING WARNING WARNING WARNING WARNING • To reduce the risk of fire, electric shock, or injury to persons, observe the following: a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
Page 23
Safety SAFETY PRECAUTIONS WARNING WARNING WARNING WARNING WARNING • To reduce the risk of a range top grease fire: a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
Page 24
• This blower assembly is approved for use with the following Electrolux retractable ventilation systems: E30DD75ESS, E36DD75ESS, E46DD75ESS and E48DD75ESS only. Use of this blower assembly with any other product or in any other configuration is hazardous and voids the product warranty.
Planning for Installation INSTALLATION PLANNING A qualified technician must complete the installation of this appliance. Carefully check the location where the remote blower is to be installed. The remote blower should be placed for convenient access. Make certain that electrical power can be provided in the selected location.
Page 28
Planning for Installation Blower Overall Dimensions Overall Chassis Overall Chassis Overall Chassis Duct Model Width Height Length Diameter 5304444802 26” (660mm) 9 9/16” (243mm) 33 1/2” (851mm) 10” (254mm) Blower Specifications Model Electrical Maximum Total Approx. Finish Supply Duct Connected Rating* Shipping Requirements...
Page 29
Planning for Installation NOTE The blower must be sealed between the roof or wall and the underside of the flange with mastic to prevent leaks. For installation on a flat roof, or a roof with a pitch of less than 2:12, install the blower on a curb as shown below.
Page 30
Planning for Installation Blower Roof Installation Side View Blower Discharge 45° Adjustable Elbow 3 1/4" x 10" to Round Transistion Cooktop 3 1/4" x 10" 3 1/4" x 10" 90° Elbow 90° Elbow Figure 6...
Making the Electrical Connection ELECTRICAL CONNECTION WARNING WARNING WARNING WARNING WARNING Ensure that the power supply is disconnected before proceeding. Verify that the power supply matches the ratings found on the appliance data plate before proceeding. The complete appliance must be properly grounded at all times when electrical power is applied.
2. Check the electrical connections to ensure that the installation has been completed correctly. 3. Repeat the above test. 4. If the appliance still does not work, contact Electrolux at 1-877-4Electrolux. Do not attempt to repair the appliance yourself. Electrolux is not responsible for service required to correct a faulty installation.
Need help?
Do you have a question about the E30DD75ESS and is the answer not in the manual?
Questions and answers