First Use; Personalisation; Daily Use - Zanussi ZWI 71201 WA User Manual

Front-loading washing machine
Hide thumbs Also See for ZWI 71201 WA:
Table of Contents

Advertisement

• you are washing a small load
• the laundry is lightly soiled
• large amounts of foam form during washing.
Degrees of water hardness
Water hardness is classified in so-called "degrees" of
hardness. Information on hardness of the water in your

First use

• Ensure that the electrical and water connections
comply with the installation instructions.
• Remove the polystyrene block and any material
from the drum.
• Pour 2 litres of water into the main wash com-
partment
of the detergent drawer in order to

Personalisation

Acoustic signals
The machine is provided with an acoustic device, which
sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultaneously for about
6 seconds, the acoustic signal is deactivated (except if
there is a fault). By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unattended
so you do not need to worry that children might be injured

Daily use

Load the laundry
www.zanussi.com
Open the door by carefully
pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them
out as much as possible.
Close the door.
area can be obtained from the relevant water supply com-
pany, or from your local authority. If the water hardness
degree is medium or high we suggest you to add a water
softener following always the manufacturer's instructions.
When the degree of hardness is soft, readjust the quantity
of the detergent.
activate the ECO valve. Then run a cotton cycle at
the highest temperature without any laundry in
the machine, to remove any manufacturing resi-
due from the drum and tub. Pour 1/2 a measure
of detergent into the main wash compartment and
start the machine.
by or cause damage to the appliance. This function re-
mains enabled also when the washing machine is not
working.
There are two different ways to set this option:
1.
Before pressing button 7: it will be impossible to
start the machine.
2.
After pressing button 7: it will be impossible to
change any other programme or option.
To enable or disable this option press simultaneously for
about 6 seconds buttons 2 and 3 until on the display, the
icon
appears or disappears.
Make sure that no laundry
stays between the seal and
the door. There is a risk of
water leakage or damage
to the laundry.
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zwi 71401 wa

Table of Contents