Zanussi ZWG 5120 P User Manual page 12

• Remove the drawer. Push the drawer edge out-
wards where indicated by the arrow (PUSH) to fa-
cilitate drawer removal.
The flap is down and you wish to use powder detergent:
The flap is up and you wish to use liquid detergent:
• Measure out the detergent.
For the quantity of detergent, refer always to
what is written on the product packing and en-
sure that the detergent can be poured in the drawer.
Set your washing programme
The control panel permits to select a washing programmes and different options.
When an option button is selected, the corresponding pilot light is on. Otherwise it is off.
For compatibility among washing programmes and options, see the "Washing Programme Chart". If an in-
correct option is selected, the integrated red pilot light of the button 6 flashes 3 times.
12
• Rotate the flap up-
wards. Ensure to fit the
flap completely in.
• Carefully put the draw-
er back.
• Measure out the deter-
gent.
• Pour the powder deter-
gent into the main
wash compart-
ment .
• Rotate the flap down-
wards.
• Carefully put the draw-
er back.
• Pour the liquid detergent in the compartment
without exceeding the limit indicated in the flap.
The detergent must be placed in the appropriate
compartments of the dispenser drawer before start-
ing the wash programme.
Warning! Do not use the flap in "DOWN" position
with:
• Gelatinous detergent or thick detergent.
• Powder detergent.
• With programmes with prewash.
• Do not use liquid detergent if the washing pro-
gramme doesn't start immediately.
In all above listed cases, use the flap in "UP" posi-
tion .
Measure out the fabric softener
Close the detergent dispenser drawer
Pour fabric softener or
any additives into the
compartment marked
(do not exceed the
«MAX» mark in the draw-
er). Any additives must
be placed in the appropri-
ate compartments of the
dispenser drawer just be-
fore starting the wash pro-
gramme.