Zanussi ZWG 5120 P User Manual page 15

Extra Rinse
Start/Pause
6
Indicator pilot lights
7.1
Hoofdwas
Lavage
7.2
Extra spoelen
Rinçage plus
Einde
7.3
Fin
At the end of the programme
The appliance stops automatically. The pilot light of the
button 6 and the pilot light corresponding to the just fin-
ished washing phase go off. The light 7.3 illuminates.
This appliance is designed for saving water. However, for people with
very delicate skin (allergic to detergents) it may be necessary to rinse the
laundry using an extra quantity of water.
Press simultaneously the buttons 4 and 5 for some seconds: the pilot
light 7.2 comes on. This function stays permanently on. To remove it
press the same buttons again until the pilot light 7.2 goes off.
Start the programme by pressing the button 6
• To start the selected programme, press the button 6 , the correspond-
ing green pilot light stops flashing. The pilot light 7.1 illuminates to
indicate that the appliance starts operating and the door is locked. If
you have chosen a delayed start, the appliance will begin the countdown.
• To interrupt a programme which is running, press the button 6 : the
corresponding green pilot light starts flashing. It is possible
to change some options of a running programme before the pro-
gramme carries them out.
• To restart the programme from the point at which it was interrupted,
press the button 6 .
• After the programme has started the door is locked. If, for any reason,
you need to open the door , set firstly the appliance to PAUSE by press-
ing the button 6 . After a few minutes it will be possible to open the door.
If the door remains locked, this means that the appliance is already
heating or that the water level is too high. In any case, do not try to
force the door!
If you cannot open the door but you need to open it you have to
switch the appliance off by turning the selector dial to
minutes the door can be opened ( pay attention to the water level and
temperature! ). After closing the door, it is necessary to select the pro-
gramme and options again and to press the button 6 .
• When you start the programme by pressing the button 6 , the washing
phase pilot light ( 7.1 ) illuminates. This means that the appliance is
operating.
• The additional rinses pilot light ( 7.2 ) illuminates when the appliance
perform an extra rinse.
• When the programme has finished the end cycle pilot light ( 7.3 )
comes on.
If a programme or an option that ends with water left in
the tub has been selected and the door remains locked
to indicate that the water must be emptied out before
opening the door.
Follow the below instructions to empty out the water:
. After a few
15