Zanussi ZWG 5120 P User Manual page 8

Accurate levelling prevents vibration, noise and dis-
placement of the appliance during operation.
Repeat the levelling action, if the appliance is not lev-
el and stable.
Water inlet
35°
Loosen the ring nut to angle the hose to the left or
right depending on the position of your water tap. Do
not place the inlet hose downwards. After positioning
the inlet hose, be sure to tighten the ring nut again to
prevent leaks.
Water drainage
8
Connect the hose to a tap
with a 3/4" thread.
45°
Firstly form a hook in the end of the drain hose using
the plastic hose guide supplied with the appliance .
The end of the drain hose can be positioned in three
ways:
• Hooked over the edge of a sink using the plastic
hose guide.
Tie the plastic hose guide to the tap with a string to
prevent that the drain hose unhooks when the appli-
ance is emptying.
• Onto a sink outlet spigot.
Push the drain hose onto the spigot and secure with a
clip, ensure a loop is formed in the drain hose to pre-
vent waste from the sink entering the appliance.
If the outlet spigot has not been used before, remove
any blanking plug that may be in place.
• Directly into a drain pipe at a height of not less
than 60 cm and not more than 100 cm.
• Directly to a built-in drain pipe in the room wall.
The end of the drain hose
must always be ventila-
ted , i.e. the inside diame-
ter of the drain pipe must
be larger than the outside
diameter of the drain
hose. The drain hose
must not be kinked.