Brother MFC-8480DN User Manual page 156

Error Message
Document Jam
DR Mode in Use
Drum Error
Duplex Disabled
Fuser Error
Jam Duplex
Jam Rear
Jam Inside
Jam MP Tray
Jam Tray 1
Jam Tray 2
No Paper
No Response/Busy
No Toner
No Tray
140
Cause
The document was not
inserted or fed properly, or the
document scanned from the
ADF was too long.
The machine is set to
Distinctive Ring mode. You
cannot change the Receive
Mode from Manual to another
mode.
The corona wire on the drum
unit needs to be cleaned.
The drum unit has reached the
end of its life.
The duplex tray is not installed
properly.
The temperature of fuser unit
does not rise at a specified
temperature within specified
time.
The fuser unit is too hot.
The paper is jammed in the
duplex tray.
The paper is jammed in the
back of the machine.
The paper is jammed inside
the machine.
The paper is jammed in the MP
tray of the machine.
The paper is jammed in the
paper tray of the machine.
The machine is out of paper or
paper is not properly loaded in
the paper tray.
The number you dialed does
not answer or is busy.
The toner cartridge or the drum
unit and toner cartridge
assembly is not installed
properly.
The paper tray is not
completely closed.
Action
See Document jams on page 145 or Using the
automatic document feeder (ADF) on page 20.
Set Distinctive Ring to Off. (See Turning off
distinctive ring on page 57.)
Clean the corona wire on the drum unit. (See
Cleaning the corona wire on page 157.)
Replace the drum unit. (See Replacing the
drum unit on page 164.)
Remove the duplex tray and install it again.
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine for
15 minutes with the power on. The machine can
be turned off for approximately 60 hours without
losing faxes stored in the memory. (See
Transferring your faxes or Fax Journal report
on page 144.)
(See Paper jams on page 147.)
(See Paper jams on page 147.)
(See Paper jams on page 147.)
(See Paper jams on page 147.)
(See Paper jams on page 147.)
Do one of the following:
Refill the paper in the paper tray or MP tray.
Remove the paper and load it again.
Verify the number and try again.
Re-install the toner cartridge or the drum unit
and toner cartridge assembly.
Close the paper tray properly.