Front Wheel - Yamaha TW200Z Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Front wheel

To remove the front wheel
1
WARNING
2
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
3
1. Disconnect the speedometer ca-
ble from the front wheel.
4
2. Loosen the axle nut.
5 1
6
7
8
1. Speedometer cable
9
2. Axle nut
3. Lift the front wheel off the ground
according to the procedure in
"Supporting the motorcycle" on
EAU24360 page 7-35.
4. Remove the axle nut, pull the
wheel axle out, and then remove
EAU24582
the wheel. NOTICE: Do not apply
the brake after the wheel has
EWA10821
been removed together with the
brake disc, otherwise the brake
pads will be forced shut.
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2
1. Speedometer gear unit
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
[ECA11071]
EAU24981
1. Speedometer gear unit retainer
2. Speedometer cable
1
7-36
1
3. Insert the wheel axle, and then in-
stall the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
90 Nm (9.0 m·kgf, 65 ft·lbf)
2