Rear Wheel - Yamaha TW200Z Owner's Manual

6. Connect the speedometer cable.
PERIODIC MAINTENANCE AND ADJUSTMENT

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
3. Turn the drive chain adjusting
plate on each side of the swingarm
fully in direction (a).
7-37
EAU25080
2
EAU25421
EWA10821
(a)
1
1. Axle nut
2. Brake pedal free play adjusting nut
3. Brake rod
4. Brake camshaft lever
5. Drive chain slack adjusting plate
4. Lift the rear wheel off the ground
according to the procedure on
page 7-35.
5. Remove the axle nut, and then pull
the wheel axle out.
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
3
4
2
5
3
4
5
6
7
8
9