Advertisement
INSTALLATION GUIDE
TALKING ALARM • MODEL 3001
CONTENTS
System Features .......................................
Technical Assistance ..................................
Wiring Instructions ...................................
Installation Instructions ............................. 3
Operating Instructions .............................. 4-5
All tech personnel are expertly qualified to answer any technical questions.
Technicians are available Monday through Friday from 9:00 a.m. until 8:00 p.m. and Saturday 10:00 a.m. until 4:00 p.m.
OWNER'S GUIDE
Technical Assistance
Address
288 Canton Avenue • Wintersville, Ohio 43953
Telephone
Phone: 740-264-4710 • 800-878-8007 • Fax: 740-264-7306
•
1
1
2
Advertisement
Table of Contents
Related Manuals for Bulldog Security 3001
Summary of Contents for Bulldog Security 3001
- Page 1 INSTALLATION GUIDE • OWNER’S GUIDE TALKING ALARM • MODEL 3001 CONTENTS System Features ........Technical Assistance ........Wiring Instructions ........Installation Instructions ......3 Operating Instructions ......4-5 Technical Assistance All tech personnel are expertly qualified to answer any technical questions. Technicians are available Monday through Friday from 9:00 a.m.
-
Page 2: System Features
SYSTEM FEATURES Two Four Button Remotely activates alarm in chirp or voice mode. Activates car finder and Remote Controls instant panic. High Quality Siren Speaker Extremely loud siren and voice deters thief from further tampering. Battery Back-Up (Optional) Alarm will continue to sound even with vehicle battery disconnected. Current Sensing Activates after 45 seconds. - Page 3 IT IS STRONGLY RECOMMENDED THAT THIS INSTALLATION MANUAL IS READ PRIOR TO INSTALLATION. This security system is not a “Do-it-yourself” product. Instructions are NOT provided or enclosed. Installation performed by non-Bulldog dealers or consumers will NOT be supported by Bulldog Security.
- Page 4 INSTALLATION INSTRUCTIONS GREEN - NEGATIVE TRIP VOICE GREY - NEGATIVE TRIP ALARM YELLOW - ANTENNA ORANGE LOOP OPTIONAL GROUND BASE TO BATTERY FUSE LED LIGHT BLUE - NEGATIVE OUTPUT...
-
Page 5: Operating Instructions
OPERATING INSTRUCTIONS NOTE: Before operating your alarm, slide the protector down (attached to the back of your remote transmitter) snap off the back and snap to the front. Arming Press transmitter button #1 (Arm Talk). The alarm will set and a man's voice will acknowledge by saying "System Armed”. - Page 6 Automatic (Passive) Arming To activate passive arming. Press and hold down transmitter button #2 (arm chirp) for 10 seconds. Alarm will respond with a tone and then say “system armed”. Your alarm will automatically arm itself in 60 seconds after each time you turn off your engine. After disarming your system, you have approximately 60 seconds to start your motor before the alarm will rearm itself.
Need help?
Do you have a question about the 3001 and is the answer not in the manual?
Questions and answers