INSTALLATION GUIDE OWNER’S GUIDE REMOTE STARTER MODELS RS82 AND RS85 CONTENTS System Features ... System Components ... Required Tools ... Technical Assistance... Before You Begin ... Precautions... Using your Test Probe... Making Wiring Connections ... 2-4 Locating & Making Connections ... 4-5 Connecting the 11-Pin Harness and the 4-Relay Harness ..6...
It is computer controlled and manufactured in the U.S.A. The dependability and variety of features make Bulldog Security the leader in the industry. Enjoy your new remote starter for years to come! This remote system is designed to start your vehicle by sending a command signal from the remote transmitter.
MAKE SURE YOU PLACE THE WARNING STICKER UNDER YOUR HOOD. For Model RS82 or RS85 follow the instructions until you reach page 13. For RS85 only, continue. PRECAUTIONS This system is designed for use with vehicles equipped with fuel-injected, gasoline engines with automatic transmissions only.
Page 4
4. Insert the wire(s) from the starter through the hole as shown. If two or more wires are inserted, wrap them in opposite directions. 5. Wrap the wire around one side then the other and finally around itself as shown. 6.
4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection. Secure with wire ties as shown. Use this method ONLY when connecting two separate wires end to end. LOCATING & MAKING CONNECTIONS Please see the wiring chart on this website, www.bulldogsecurity.com/wires.htm.
Page 6
Parking Light Output (-) (Optional Part #775 required) Probe the wire(s) coming from your head- lamp switch. Find the wire that will show +12V when the parking lights are ON and ground when the lights are OFF. Connect the YELLOW wire from Part #775 to this wire. Connect the BROWN wire from the 11-pin harness to the WHITE wire on Part #775.
MODEL RS82 OPERATOR PROGRAMMING INSTRUCTIONS Adding Additional Remotes The hood must be open. Then, press and hold Button #1 on the working transmitter for six (6) seconds or until the ignition relay clicks or the “check engine light”...
Programming to Start your Vehicle with your Factory Keyless Entry Press and hold the brake, press and hold Button #1 on the Bulldog Security remote until the parking lights flash once (if connected) or for approximately six (6) seconds or until the unit clicks or flashes. Release.
Need help?
Do you have a question about the RS82 and is the answer not in the manual?
Questions and answers