Bulldog Security 2002 Installation And Owner's Manual

Talking alarm

INSTALLATION GUIDE

TALKING ALARM • MODELS 2002

CONTENTS

System Features .......................................

Technical Assistance ..................................

Installation Instructions............................ 1-2

Operating Instructions .............................. 2-3

All tech personnel are expertly qualified to answer any technical questions.

Technicians are available Monday through Friday from 9:00 a.m. until 8:00 p.m. and Saturday 10:00 a.m. until 4:00 p.m.

OWNER'S GUIDE

Technical Assistance

Address

288 Canton Avenue • Wintersville, Ohio 43953

Telephone

Phone: 740-264-4710 • 800-878-8007 • Fax: 740-264-7306

•

Table of Contents

Need help?

Do you have a question about the 2002 and is the answer not in the manual?

Page 1 INSTALLATION GUIDE OWNER’S GUIDE TALKING ALARM • MODELS 2002 CONTENTS System Features ... Technical Assistance ... Installation Instructions... 1-2 Operating Instructions ... 2-3 All tech personnel are expertly qualified to answer any technical questions. Technicians are available Monday through Friday from 9:00 a.m. until 8:00 p.m. and Saturday 10:00 a.m. until 4:00 p.m.
Page 2: System Features
SYSTEM FEATURES One Piece Self-Contained Fast and easy to install, usually 5 to 10 minutes with no experience. Only One Wire Fits virtually any vehicle. Two Long Range Four Remotely activates alarm in chirp or voice mode. Slide protection stops Button Remote Controls accidental alarm activation.
Page 3: Operating Instructions
3. Connect the Red power wire with the supplied alligator clip to any constant +12 volt supply. (Example: Battery) If installation is correct, alarm will say “Thank You”. (See figure #3) 4. (Optional) For even greater protection, you may now install a 9-volt alkaline battery. allow your alarm to operate in the event of a dead or disconnected battery.
Page 4 #2 twice within 2 seconds your alarm will respond by saying “Thank you” twice indicating it received your command. When arming with transmitter button #2, simply reverse the procedure. The next time the alarm is set it will go back to the original setting. Setting the Current Sensor Disarm the system.