Attaching The Cable Cover - NEC NP-PE401H User Manual

Introduction
CAUTION:
• Be sure to tighten
the screws after
attaching the cable
cover. Failure to do
so may cause the
cable cover to come
off and fall, result-
ing in injury or
damage to the cable
cover.
• Do not put bundled
cables in the cable
cover. Failure to do
so may damage the
power cord, result-
ing a fire.
English ... 10
8 POWER ON/
OFF and LED
indicator
9 ECO
10 SOURCE
11 AUTO ADJ.
12 STATUS LED
13 LAMP LED

Attaching the Cable Cover

Cable Cover
2
Procedure for Attaching the Cable Cover:
1. Mount the cable cover to the projector. 
2. Tighten two screws on both sides of the cable cover. 
Power on the projector. Refer to
the "Power On/Off the Projec-
tor" section on pages 27-28.
Dim the projector lamp which
will lower power consumption
and extend the lamp life. (refer
to page 52)
Press "SOURCE" to select an
input signal.
Automatically synchronize the
projector to the input source.
Indicate the projector's tempera-
ture status.
Indicate the projector's lamp
status.
1