Printing Problems; The Machine Does Not Print. (On Line Indicator ( ) Does Not Blink.); The Machine Does Not Print. (On Line Indicator ( ) Was Blinking.) - Olivetti d-Copia 2001 Operator's Manual

TROUBLESHOOTING

PRINTING PROBLEMS

In addition to this section, troubleshooting information can also be found in the README files for each of the
software programs. To view a README file, see the "Software Setup Guide".
Problem
The machine does not print.
(ON LINE indicator ( ) does not
blink.)
The machine does not print.
(ON LINE indicator ( ) was
blinking.)
52
Cause and solution
The machine is set to off-line mode.
→ Press the [ON LINE] key (
( ).
The machine is not correctly connected with your
computer.
→ Check both ends of the printer cable and make sure you have a
solid connection. Try a known good cable. For information on
cables, see "SPECIFICATIONS".
Copy job is performed.
→ Wait until the copy job is complete.
The port setting is not correct.
→ Printing is not possible if the printer driver port setting is not
correct. Set the port correctly.
Your machine is not selected correctly in the current
application for the print job.
→ When choosing "Print" from the "File" menu located in
applications, be sure you have selected "Olivetti d-Copia XXXX"
(where XXXX is the model name of your machine) printer
displayed in the "Print" dialog box.
The printer driver has not been installed properly.
→ Follow these steps to check and see if the printer driver is
installed.
1 Click the "start" button, click "Control Panel", click "Printers
and Other Hardware", and then click "Printers and Faxes".
(On Windows 95/98/Me/NT 4.0/2000, click the "Start" button,
select "Settings" and then click "Printers".)
2 The "Olivetti d-Copia XXXX" printer driver icon is not shown.
(where XXXX is the model name of your machine)
3 If the icon is shown but you still cannot print, the printer driver
may not have been installed correctly. In this case, delete the
software and then reinstall it.
The tray size settings are not the same on the machine
and in the printer driver.
→ Make sure that the same tray paper size is set on the machine
and in the printer driver. To change the tray's paper size setting on
the machine, see "CHANGING A TRAY'S PAPER SIZE
SETTING" or see the "Software Setup Guide" to change it in the
printer driver.
The specified size of paper has not been loaded.
→ Load the specified size of paper in the paper tray.
The PAPER SIZE indicator is blinking.
→ When "Use close paper size (user program)" is disabled, the
PAPER SIZE indicator on the operation panel will blink. You can
press the [TRAY SELECT] key (
load paper in the bypass tray and press the [ON LINE] key (
begin printing.
→ When "Use close paper size" is enabled, printing will take place
using a size of paper that is close to the size of the print image.
) to turn on the ON LINE indicator
) to select a tray manually, or
Page
36
71
–
Software
Setup
Guide
–
–
16
Software
Setup
Guide
14
16, 21
) to
–