Operating instructions for Washing machine Paragon Plus en - GB To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 07 171 260...
Caring for our environment Disposal of the packing Disposal of your old appliance material or machine The transport and protective packing Electrical and electronic appliances / has been selected from materials which machines often contain materials are environmentally friendly for disposal which, if handled or disposed of and can normally be recycled.
Warning and Safety instructions This washing machine is not This washing machine conforms to intended for use by persons (including current safety requirements. children) with reduced physical, Inappropriate use can, however, sensory or mental capabilities, or lack lead to personal injury and damage of experience and knowledge, unless to property.
If the connection cable is faulty it data on the data plate (voltage and must only be replaced by a Miele connected load) match the mains approved service technician to protect electricity supply. If in any doubt, the user from danger.
A special descaling agent is available to order from the Miele Spare Parts Department or via the internet on www.miele.co.uk.
Accessory parts may only be fitted damage to component parts and create when expressly approved by Miele. If toxic fumes. Such agents also pose a other parts are used, guarantee, fire and explosion hazard.
Description of the machine Control panel a Programme buttons e- f Sequence indicator lights For selecting a washing programme. Show which section of the wash programme has been reached. b Soiling button g Buzzer button For specifying the degree of soiling of the laundry.
Description of the machine Display Delay start The display shows: The delay start time selected will appear in the display. – the programme duration (Time left display) After the machine has started, the delay start time counts down. If the delay start –...
Before using for the first time Before using the machine for the first time ensure that it is correctly installed and connected. See "Installation and connection". Also check that the drain filter is securely tightened to prevent the risk of water leaks during use.
Washing environmentally and economically Energy and water consumption Degree of soiling – Water consumption and energy With most of the programmes you can usage are determined by the size of specify the degree of soiling of the the load. laundry. The washing machine will then To make the most out of your adjust the programme to suit the machine, load the maximum dry load...
How to wash correctly Brief instructions If you use a solvent-based clean- The headings numbered A, B, C, . . . ing agent (e.g. one containing ben- show the operating sequence and can zene) to pre-treat a stain, make sure be used as brief instructions.
How to wash correctly B Switch on the washing machine D Select a programme C Load the drum ^ Press the Door button to open the drum door. ^ Unfold the laundry and load loosely in the drum. Mixing both large and small items gives better wash results and also helps distribute the load evenly during spinning.
How to wash correctly Specify the degree of soiling of the You can change the pre-set temperature or spin speed by pressing laundry the Temperature or Spin button. Press the top button to select the degree of soiling. Normal is the default In some programmes the maximum setting.
How to wash correctly E Add detergent It is important to dispense the correct amount, because ..too little detergent results in: – Laundry not getting properly clean and with time it may become grey and hard to the touch.
How to wash correctly F Select Delay Start, if wished ^ Remove the laundry. Delay start allows you to delay the start Only remove laundry from the of a programme from 30 minutes up to machine once the drum has a maximum of 24 hours, allowing you to stopped turning.
Degree of soiling, Water plus, Buzzer Water plus The washing machine will adjust the programme to suit the degree of soiling If the Water plus button is pressed, the selected. water level in the main wash and rinses is increased. Light You can also alter the setting allocated to the Water plus button.
Spinning Final spin speed To omit the final spin (Rinse hold) ^ Select the Rinse hold setting. The Programme laundry will not be spun and will Automatic 1200 remain suspended in the final rinse Cottons 1400 water. This reduces creasing if the Minimum iron/Delicates 1200 laundry is not going to be removed...
Programme chart Automatic 7621* cold to 40°C Max. load 3.5 kg Fabric Mixed loads of garments suitable for the Cottons and Minimum iron/ Delicates programmes. Sort according to colour. Note The wash parameters (e.g. water level, wash rhythm and spin speed) are adjusted automatically in this programme to ensure the best possible care and wash result for each item.
Programme chart Silks /c* cold to 30°C Max. load 2.0 kg Fabric Silks and other handwashable fabrics with no wool content, e.g. satin, lace and silk. Note Place socks, tights, bras etc. in a washing bag. Express 76* cold to 40°C Max.
Programme sequence Main wash Rinses Spinning Water Wash Water Rinses Interim Final level rhythm level spin spin Automatic Cottons Minimum iron/ Delicates Woollens Silks – Dark garments Shirts – Express Denim – Drain/Spin – – – – – d = Low water level a= Normal wash rhythm ( = Medium water level b= Minimum iron/Delicates...
Programme sequence This machine has fully electronic Special features in the programme controls with automatic load sequences: recognition. It takes in the right amount Anti-crease: of water required for the programme depending on the amount of laundry At the end of every programme, with and its absorbency rate.
Garment care label symbols Washing Ironing The figure quoted in the bucket is the The number of dots indicates the maximum temperature the garment ironing temperature can be washed at. The number of Hot iron (max sole plate temp. bars under the symbol indicates the approx.
Changing the programme sequence Cancelling a programme Changing a programme You can cancel a programme at any Wash programme time after it has started. After the start of a programme it is no ^ Press the Start/Stop button briefly. longer possible to select a different The suds will be pumped away and the programme.
Changing the programme sequence Adding or removing laundry Safety lock after a programme has started The safety lock prevents the machine ^ Press the Door button to open the from being opened or the drum door. programme cancelled or the temperature or spin speed being ^ Add or remove items.
Changing the programme sequence System lock The system lock prevents your machine being used without your knowledge. If the system lock has been activated it is not possible to start a programme. To activate the system lock Before you begin, first ensure that: –...
For programmes with a pre-wash you will need to purchase a special container from the Miele Spare Parts department which sits in the main wash compartment j of the detergent dispenser drawer. Add liquid detergent to this container for the main wash and to compartment i for the pre-wash.
In the UK, Miele branded water Normally soiled softening tablets are available from the Visibly dirty and/or just a few slight Miele Spare Parts Department or via the stains. internet on www.miele.co.uk. Heavily soiled Use a quantity of detergent as for soft Visible dirt and stains and/or dried on water.
Detergent Fabric conditioners and liquid If starching frequently, clean the starch dispenser compartment and Fabric conditioners make garments soft especially the siphon tube and to handle and help prevent static cling conditioner channel regularly. See when tumble drying. "Cleaning the detergent dispenser drawer".
A microfibre "E-Cloth" is available from same time pull the drawer right out of the Miele UK Spare Parts Department the machine. or via the internet on www.miele.co.uk, which is suitable for cleaning surfaces...
Cleaning and care Cleaning the water inlet filters To clean the filter in the water inlet valve: The washing machine has two filters to ^ Using pliers, carefully loosen the protect the inlet valves. ribbed plastic nut on the inlet valve These filters should be checked every and unscrew.
Cleaning and care With the help of the following notes, minor faults in the performance of the appliance, some of which may result from incorrect operation, can be put right without contacting the Service Department. Repair work to electrical equipment should only be carried out by a suitably qualified person in strict accordance with current local and national safety regulations.
– the inlet hose is kinked. The filter in the water Clean the filter. inlet hose is dirty. The Miele Waterproof Call the Service Department The buzzer sounds and the Water inlet and Drain system has reacted.
Cleaning and care General problems Problem Possible cause Remedy The Detergent check Excessive foam has Use less detergent next time light comes on. built up during washing. and follow the manufac- turer's instructions on dos- age given on the packaging. The Rinses Sequence There is a fault.
Cleaning and care An unsatisfactory wash result Problem Possible cause Remedy Liquid detergent Liquid detergents – Use a general purpose does not give the usually contain no detergent containing a required result. bleaching agents. bleaching agent. They do not remove –...
Cleaning and care The drum door does not open when you press the Door button Possible cause Remedy The machine is not Insert the plug in the socket and switch on. connected to the electricity supply. The machine is not Switch the machine on with the I-On/0-Off button.
Cleaning and care Opening the drum door in the Blocked drain outlet event of a blocked drain outlet If the drain outlet is blocked, up to and/or power failure 25 litres of water will be retained in the machine. ^ Switch the washing machine off. There is a lever behind the detergent Caution: if laundry has been drawer fascia panel.
Cleaning and care Once the flow of water ceases: Make sure the drain filter is securely tightened. Otherwise there is a risk of water leakage during use. Opening the drum door Always make sure that the drum is stationary before reaching into the machine to remove laundry.
Optional accessories porthole glass when the door is open. Optional accessories for this washing machine are available from your Miele Dealer or from the Miele Spare Parts Department. Please note that telephone calls may be monitored and recorded for training purposes.
Installation and connection Front view a Inlet hose (tested to withstand h Detergent dispenser drawer pressure of at least 7,000 kPa) i Drum door b Electricity supply cable j Access to drain filter, drain pump c - f Flexible drain hose (with and emergency release detachable swivel elbow) k Handle recesses for moving the...
Installation and connection Rear view a Protruding lid for holding when e Transit bar covers moving the machine f Restraining clip for inlet hose and b Electricity supply cable drain hose c Inlet hose (tested to withstand g Restraining clips for transit bars pressure of at least 7,000 kPa) when removed d Drain hose...
^ To remove the left and right covers raised plinth, it has to be secured against slippage during spinning 1. Use a screwdriver to prise out the using retaining clips (available from cover as illustrated. the Miele Spare Parts Dept). 2. Pull the cover forwards to remove.
Installation and connection ^ Using the spanner supplied turn the ^ Turn the right-hand transit bar 90°, left-hand transit bar 90°, then then ^ withdraw the transit bar. ^ withdraw the transit bar.
Installation and connection To avoid the risk of injury the holes for the transit bars must be covered after the transit bars have been removed. ^ Secure the transit bars to the back of the washing machine. Make sure that holes b are fitted over retainers a.
Installation and connection Levelling the machine The machine must stand perfectly level on all four feet to ensure safe and proper operation. Incorrect installation may increase electricity and water consumption and may cause the machine to move about. Screwing out and adjusting the feet The four adjustable screw feet are used to level the machine.
Installation and connection Washer and Dryer stack The fitting of building under kits and A Miele tumble dryer can be stacked stacking kits must only be with the washing machine. A "WTV" undertaken by qualified and stacking kit* is necessary and can be...
– Overflow protection system This prevents the washing machine taking in too much water. If the water The Miele water protection system level exceeds a certain level, the protects the washing machine from drain pump switches in and pumps water damage.
5 m. The machine. necessary parts can be purchased 2. Connected securely to a plastic from the Miele Spare Parts Department drain pipe with a rubber nipple. or your Miele dealer. There is no need to use a non-return * For a delivery head of more than 1 m valve.
Installation and connection Electrical connection U.K. Non-rewireable plugs BS 1363 All electrical work should be carried out The fuse cover must be refitted when by a suitably qualified and competent changing the fuse, and if the fuse cover person, in strict accordance with is lost, the plug must not be used until a current national and local safety suitable replacement is obtained.
Consumption data Load Consumption data Energy Water Degree of soiling in kWh in litres Light Normal 40°C 3.5 kg 0.35 - 0.50 40 - 55 1 h 03 min 1 h 18 min Automatic Cottons 95°C 6.0 kg 1.99 2 h 09 min 60°C 6.0 kg 1.02...
Technical data Height 850 mm Width 595 mm Depth 580 mm Depth with door open 975 mm Weight 93 kg Maximum floor load 1,600 Newton (approx. 160 kg) Capacity 6 kg dry laundry Voltage see data plate Connected load see data plate Fuse rating (UK) see data plate / plug Consumption data...
Programmable functions for changing default settings The programmable functions can be used to tailor washing programmes to suit your individual requirements.
Programmable functions Water plus system A Press the Start/Stop button and keep it pressed in whilst carrying out steps This is used to select the water intake B-C. setting for the Water plus button. B Press the I-On/0-Off button in. There are three different options: C Wait until the indicator light for the Start/Stop button comes on .
Programmable functions Gentle action A Press the Start/Stop button and keep it pressed in whilst carrying out steps Activating gentle action reduces the B-C. drum action and is suitable for B Press the I-On/0-Off button in. washing slightly soiled articles more gently.
Programmable functions Suds cooling in the Cottons A Press the Start/Stop button and keep it pressed in whilst carrying out steps programme B-C. When this is activated, additional B Press the I-On/0-Off button in. water flows into the drum at the end C Wait until the indicator light for the of the main wash to cool the suds Start/Stop button comes on .
Programmable functions Increase the duration of the A Press the Start/Stop button and keep it pressed in whilst carrying out steps main wash B-C. This setting is used to select the B Press the I-On/0-Off button in. length of time (15, 30 or 60 minutes) C Wait until the indicator light for the by which the main wash is increased Start/Stop button starts comes on .
Programmable functions Buzzer A Press the Start/Stop button and keep it pressed in whilst carrying out steps When the buzzer function has been B - C. activated, an audible tone sounds at B Press the I-On/0-Off button in. the end of a programme or when Rinse hold is reached.
Programmable functions Keypad tones A Press the Start/Stop button and keep it pressed in whilst carrying out steps An audible tone sounds each time a B - C. button is pressed. B Press the I-On/0-Off button in. The washing machine is delivered with C Wait until the indicator light for the the keypad tone switched off.
Programmable functions Memory function A Press the Start/Stop button and keep it pressed in whilst carrying out steps If an additional option is selected for B - C. a programme, and / or the spin B Press the I-On/0-Off button in. speed is altered, the machine stores these changes in memory at the start C Wait until the indicator light for the...
Programmable functions Pre-wash with the Heavy A Press the Start/Stop button and keep it pressed in whilst carrying out steps Degree of soiling option B-C. This setting is used to activate or B Press the I-On/0-Off button in. deactivate an automatic pre-wash C Wait until the indicator light for the whenever the Heavy Degree of Start/Stop button comes on .
Alteration rights reserved/3707/Paragon Plus M.-Nr. 07 171 260 / 00...