Fig. 4.17 Fitting The Core - Brother DP-525CJ Service Manual

SERVICE MANUAL
(4) Install the LCD module in the upper cover:
a) Pass the LCD module harness through the hole in the upper cover.
b) Fit the LCD module into the LCD upper cover.
c) Pass the LCD module harness through the hole in the LCD bearing. Insert the
LCD bearing into the holes in the upper cover and the LCD module and secure
it with the taptites (2 pcs.).
d) Insert the hinge assy into the holes in the upper cover and the LCD module
(LCD plate) tighten the screws (2 pcs.) while holding the hinge assy.
NOTE:
When mounting the hinge assy, push it fully into the LCD unit until the end of the hinge
assy shaft touches the rib in the LCD upper cover. See Fig. 4.18.
NOTE:
After installing the LCD module in the upper cover, attach the core to the cable.

Fig. 4.17 Fitting the Core

4-23
REPAIR
Mechanical