Table of Contents
Advertisement
Wait Time For
HACK From
Host
62
This setting specifies the time the scanner must wait to receive a HACK
message back from the host before giving up and registering a trans-
mission error. Selectable range for this wait time is 20ms to 5.1 seconds
in 20ms increments. It is recommended that this value be set at no less
than one second.
Host turnaround (ACK) time is variable. This item
(HACK) should be set based on settings for the fea-
tures Wait Time for ACK and Transmission Retries
Before Message Time-out . For example if ACK is set
to one second and retries are set to three, HACK
NOTE
should be set at three seconds.
SET -------------------------------------------
Set Wait Time For
HACK
Scan three digits representing the desired delay using the Num-
ber Pad in Appendix B. Be sure the number is padded with lead-
ing zeros (example: 001 = 20ms, 100 = 2 seconds, 255 = 5.1
seconds, etc.), then scan the END bar code.
END ------------------------------------------
Feature is specific to scanner ONLY
---------
PowerScan ™ RF Scanner
Advertisement
Table of Contents
Troubleshooting
