Sntp Client - Compaq t5300 - Thin Client Administrator's Manual

Control Panel

SNTP Client

✎
5-26
5. Select the Security tab to add/change SNMP security settings.
6. To enable an authentication failure trap, make sure the Enable
Authentication Failure Trap check box is selected.
7. To add an accepted community and assign rights to the
community:
a. Click the Add button in the Accepted Community Names
section. The Community Configuration dialog is displayed.
b. Enter the name of the community in the Community Name
field.
c. Select the rights to the community from the Rights
drop-down list and click the OK button.
8. Select the hosts from which SNMP packets may be accepted.
Choose either Accept SNMP packets from any host or Accept
SNMP packets from these hosts. If you choose the latter, enter
the host(s) as follows:
a. Click the Add button in the SNMP packets section. The
SNMP Configuration dialog is displayed.
b. Enter the host name or IP address and click the OK button.
c. Repeats steps a and b above to add as many hosts as
necessary.
9. After entering all the necessary SNMP information, click the OK
button in the upper right corner of the SNMP Network
Administration dialog box.
The SNTP GUI Applet allows administrators to synchronize the
clocks on all thin clients. Administrators can set thin clients to
automatically synchronize with an Internet time server or with a boot
server.
Synchronization can occur only when your computer is connected to
the Internet.
www.hp.com Administrator's Guide