Installation - Alpine CDA-9820XM Owner's Manual

Installation

Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Air ventilation
hole
1
Mounting Sleeve
(Included)
No Pressure Here
No Pressure Here
Remove the Detachable Front Panel (page 5).
Slide mounting sleeve from main unit. (see
"Removal" on this page).
Slide the mounting sleeve into the dashboard.
• Please examine the installation. Make certain that no external
pressure is applied to either the top of the unit or the removable
nosepiece.
2
Hex Nut (M5)
Metal
Mounting
*
Strap
Ground Lead
Chassis
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*
attached to the vehicle's chassis.
2
• For the screw marked "* ", use an appropriate screw for the
chosen mounting location.
<Rear side>
Dashboard
this unit
Screw
* 2
Bolt Stud
1
this unit
1 ) already
Connect each input lead coming from an amplifier
or equalizer to the corresponding output lead
coming from the left rear of the CDA-9820XM.
Connect all other leads of the CDA-9820XM
according to details described in the
CONNECTlONS section.
3
Lock Pin
Slide the CDA-9820XM into the dashboard. When
the unit is in place, make sure the locking pins are
fully seated in the down position. This can be done
by pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the detachable front panel.
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
this unit
Ground Lead
3
*
• Secure the ground lead of the unit to a clean metal spot using a
screw (* 3 ) already attached to the vehicle's chassis.
Face Plate
Screws (M5 × 8)
(Included)
Mounting Bracket
25
-EN