Enclosure Installation - Alpine SBV-10-WRA Installation Manual
Pre-loaded 10" subwoofer system for jeep wrangler 2007; jeep wrangler 2008; jeep wrangler 2009; jeep wrangler 2010; jeep wrangler 2011; jeep wrangler 2012; jeep wrangler 2013; jeep wrangler 2014; jeep wrangler 2015; jeep wrangler 2016; jeep wrangler 2017;
Table of Contents
Advertisement
5.
Secure the connector plugs to the left
side of the seat as shown below.
Enclosure Installation
1.
Place subwoofer enclosure on the seat floor
and connect the speaker connector to the
enclosure.
From Enclosure
Observe speaker polarity when connecting
to the speaker connector.
Ensure wires are not pinched or interfere
with any safety equipment.
Connect speaker
connector to an
amplifier (not included)
UNLIMITED
2.
Carefully position the passenger seat over the
enclosure while carefully aligning the enclosure
in between the seats brackets. Observe the
direction of the enclosure. Secure using the
18mm seat bolts (4) as shown below.
Tighten the seat bolts to 55 ft lbs
3.
Re-attach the seat belt anchor using the T45 Torx bolt.
Reconnect the two plugs under the seat.
Tighten the seatbelt bolts to 30 ft lbs
4.
Reconnect the battery terminals.
Jeep
5/6
Front ->
Advertisement
Table of Contents
